![]() ![]() So you now have the more proper way of installing titles on it (previous install progress version) and that without a hang at the end.įurthermore I added a new feature to it. It now finishes the update clean and correctly and exits back to Mii Maker / HBL without any issues. I took the time and finished up the wupinstaller stuff today that I started last weekend. Note: You can verify installation by going to System Settings/Data Management.Īnd if you ask next time about an Error -> tell us the error message or something more Note: After completing, it will hang at the WUP Installer selection menu. Copy all files from inside the title folder to the install folder on your SD card ("SD:\install\") Create a folder called install on the root of the SD cardĦ. Insert an SD card into your PC and format it to FAT32.ĥ. Download the update for the game you haveĤ. You may want to go to Settings and change your Wii U system sleep to OFF, or at least 2 hours, to prevent it from turning off mid-install!Ģ. Note: SD card must be formatted to FAT32. Since it is possible to damage your console with that software (for example by installing wrong region system titles spoofing) I have to say that I am not responsible for any damage done to your console by this software. So here are the test binaries you guys can use:īoth versions should run on any firmware that HBL runs on and have the same security as the original WUP installer by crediar. It would also be possible to list all titles on the SD card and make a menu to choose which title to install but for now its only this. In that menu you can swap the SD card (if wanted) and do another title installation or return back to HBL. After the installation is finished it enters the WUP installer menu again and tells you it finished successfully. So until then I made a 2nd version which does not show the install progress but a message that install is started and then a transition screen from system menu to mii maker while the install is running. That is why I will release the source code later when its complete. ![]() ![]() I didnt have much time to figure out what is causing this side effect but probably is something i overseen. This does not happen if I don't try to get the progress of the installation. The install is finished by that point though and it is safe to turn off the console. After the installation is finished, it shows that it is completed successfully and it tries to go back to the WUP installer selection menu and hangs on that. The first version shows the install progress on the console during the installation and you always know how far you are with it which is pretty cool but there is a side effect by that though. It went pretty quick which is why I also took the time and changed the way wup installer works by a bit to to make it work on any firmware HBL works on and I also "pimped" it a bit. As mentioned above I ported WUP installer to HBL. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |